Home › Engine / Hybrid System › 2AZ-FE FUEL › FUEL INJECTOR
RM24M0E _51 Engine / Hybrid System _059542 2AZ-FE FUEL _0291796 FUEL INJECTOR A

2AZ-FE FUEL  FUEL INJECTOR  REMOVAL  


PROCEDURE

Hide 1.DISCHARGE FUEL SYSTEM PRESSURE

CAUTION:
·

DISCHARGE FUEL SYSTEM PRESSURE procedures must be performed before disconnecting any part of the fuel system.

·

After performing the "DISCHARGE FUEL SYSTEM PRESSURE" procedures, pressure will remain in the fuel line. When disconnecting the fuel line, place a cloth or equivalent over fittings to reduce the risk of fuel spray.



a.

Fold back the floor carpet and remove the service hole cover.


b.
A126805

Disconnect the fuel pump connector.


c.

Start the engine. After the engine has stopped, turn the ignition switch off.

HINT:

DTC P0171 (system too lean) may be set.



d.

Check that the engine does not start.


e.

Remove the fuel tank cap, and let the air out of the fuel tank.


f.

Connect the fuel pump connector.


g.

Install the service hole cover and return the floor carpet to its original position.


Hide 28800 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 3.REMOVE COWL TOP OUTER PANEL WITH WINDSHIELD WIPER MOTOR AND LINK

a.

Remove the cowl top outer panel with windshield wiper motor and link (see page Vehicle Interior>WIPER / WASHER>FRONT WIPER MOTOR>REMOVAL).


Hide 77251B 5.DISCONNECT FUEL MAIN TUBE

A125337E10
2.24,2.198 2.24,2.74 false 1.021,4.25 1.031,3.896 false 1.021,4.25 1.854,4.146 false 0.969,1.271 0.708,0.969 false 0.708,0.969 0.708,0.677 false 1.948,0.479 2.677,0.646 0.729,0.167 10 false Retainer 0.031,0.021 1.042,0.375 1.01,0.354 10 false No. 2 Fuel Pipe Clamp 0.594,1.625 0.906,1.896 0.313,0.271 10 true Turn 1.979,1.854 3.073,2.188 1.094,0.333 10 true Fuel Hose Clamp 1.26,3.25 1.615,3.417 0.354,0.167 10 false Push 0.594,4.135 0.906,4.302 0.313,0.167 10 false SST

NOTICE:

Do not forcibly bend and twist the fuel main tube.


a.

Remove the fuel tube from the fuel hose clamp.


b.

Remove the fuel pipe clamp.


c.

Wipe off any dirt on the fuel tube connector.


d.

Hold the fuel tube connector, and then install SST.

SST
09268-21010  


e.

Turn SST to align the retainer inside the fuel tube connector with the chamfered part of SST.


f.

Insert SST into the fuel tube and hold it. Then push the fuel tube connector toward the SST side.


g.

Mount the retainer of the fuel tube connector onto the chamfered part of SST.


h.
A076220E64
2.188,0.76 2.26,0.406 false 2.26,1.573 2.26,1.875 false 0.594,1.375 0.594,1.708 false 1.375,0.875 1.104,0.438 1.104,0.438 1.573,0.875 false 2.917,1.323 2.917,1.531 false 2.26,0.406 2.438,0.406 false 0.542,0.313 1.021,0.51 0.479,0.198 10 false O-Ring 2.479,0.323 3.125,0.521 0.646,0.198 10 false Retainer 2.729,1.542 3.083,1.74 0.354,0.198 10 false Pipe 0.26,1.708 1.219,1.906 0.958,0.198 10 false Nylon Tube 1.948,1.865 2.573,2.063 0.625,0.198 10 false Housing

Slide SST and fuel tube connector together towards the fuel tube until they make a "click" sound, and then disconnect the fuel tube.


i.

Drain the fuel remaining inside the fuel tube.


j.

Cover the fuel tube and fuel pipe with a plastic bag to protect the disconnected part.


Hide 12262 6.DISCONNECT NO. 2 VENTILATION HOSE

a.
A097786

Disconnect the No. 2 ventilation hose from the ventilation valve.


Hide 23807 7.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

a.
A125333

Remove the 2 wire harness clamps.


b.

Disconnect the 4 fuel injector connectors.


c.
A125334

Remove the 2 bolts and then pull out the fuel delivery pipe together with the 4 fuel injectors.

NOTICE:

Be careful not to drop the fuel injectors when removing the fuel delivery pipe.



d.
A125335

Remove the 2 delivery pipe spacers from the cylinder head.


e.

Remove the 4 insulators from the cylinder head.


Hide 23250 8.REMOVE FUEL INJECTOR ASSEMBLY

a.
A097399E08
0.594,1.417 1.146,1.583 0.552,0.167 10 false Pull Out

Pull the 4 fuel injectors out of the fuel delivery pipe.