Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291794 CAMSHAFT OIL CONTROL VALVE A

2AZ-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  INSTALLATION  


PROCEDURE

Hide 11101J 1.INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.
A090053E30
1.573,0.938 1.323,0.469 false 0.677,0.333 1.177,0.521 0.5,0.188 10 false O-Ring

Apply a light coat of engine oil to the O-ring of the oil control valve.


b.
A132368

Install the oil control valve with the bolt.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:

Make sure that the O-ring is not cracked or jammed.



c.

Connect the oil control valve connector.


Hide 85110 2.INSTALL COWL TOP OUTER PANEL WITH WINDSHIELD WIPER MOTOR AND LINK

a.

Install the cowl top outer panel with windshield wiper motor and link (see page Vehicle Interior>WIPER / WASHER>FRONT WIPER MOTOR>INSTALLATION).


Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 4.CHECK FOR ENGINE OIL LEAKS

a.

Start the engine, and check that there are no oil leaks.


Hide 5.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting the cable from the negative (-) battery terminal.