Home › Engine / Hybrid System › 2GR-FE EMISSION CONTROL › AIR FUEL RATIO SENSOR
RM24M0E _51 Engine / Hybrid System _059544 2GR-FE EMISSION CONTROL _0291811 AIR FUEL RATIO SENSOR A

2GR-FE EMISSION CONTROL  AIR FUEL RATIO SENSOR  REMOVAL  


PROCEDURE

Hide 28800 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 53292A 2.REMOVE UPPER RADIATOR SUPPORT SEAL

Hide 53101 3.REMOVE RADIATOR GRILLE

a.

Remove the 3clips and screw.


Hide 86520 4.REMOVE LOW PITCHED HORN

Hide 89257 5.REMOVE COOLING FAN ECU

a.
A163954

Disconnect the cooling fan ECU connector.


b.
A163953

Remove the 2 screws and cooling fan ECU.


Hide 89467C 6.REMOVE AIR FUEL RATIO SENSOR NO.2 (for Bank 2 Sensor 1)

a.
A135166

Disconnect the sensor connector.


b.

Using SST, remove the sensor from the exhaust manifold.

SST
09224-00010  


Hide 7.REMOVE CENTER EXHAUST PIPE ASSEMBLY

a.

Disconnect the sensor connector under the center console.


b.
U188363

Remove the 2 bolts and 2 compression springs.


c.
U188365E01
1.554,0.769 1.807,0.922 0.253,0.153 10 Nut 2.629,0.865 2.906,1.011 0.277,0.145 10 Bolt 1.607,0.238 1.649,0.747 1.649,0.747 1.212,0.68 false 1.898,1.619 2.607,0.972 2.607,0.972 2.503,1.467 false

Remove the 2 bolts, 2 nuts and center exhaust pipe assembly.


Hide 8.REMOVE EXHAUST MANIFOLD RH

a.
A133293

Remove the bolt from the exhaust manifold stay shown in the illustration.


b.
A133292

Remove the 6 bolts and exhaust manifold RH.


c.

Remove the gasket and exhaust manifold to head gasket.


Hide 89467B 9.REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

a.
A135168E01
0.338,0.133 0.660,0.310 0.323,0.177 10 SST 1.355,0.784 0.718,0.219 false

Using SST, remove the sensor.

SST
09224-00010