The type of ignition switch on this model differs according to the specifications of the vehicle. For the expressions used in this section, refer to the "EXPRESSIONS OF IGNITION SWITCH" precaution (see page Engine / Hybrid System>2AZ-FE ENGINE CONTROL>SFI SYSTEM>PRECAUTION).
89467B
1.CHECK AIR FUEL RATIO COMPENSATION SYSTEM
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Select the following menu items: Data List / A/FS B1 S1 and O2S B1 S2.
Warm up the A/F sensor with the engine speed at 2,500 rpm for approximately 2 minutes.
Keep the engine speed at 2,500 rpm and confirm that the "A/FS B1 S1"display is as shown in the illustration.
The illustration may slightly differ from the display on the intelligent tester.
Only the intelligent tester displays the waveform of the A/F sensor.
Confirm that the "O2S B1 S2" display changes between 0 to 1 V with the engine speed at 2,500 rpm.
The voltage output oscillates more than 8 times in 10 seconds.
Perform the check immediately after warming the engine up.
If the voltage variation could not be verified, warm up the A/F sensor again. If it could not be verified even after warming up the sensor again, check for DTCs (see page Engine / Hybrid System>2AZ-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR).