Home › Engine / Hybrid System › 2GR-FE EXHAUST › EXHAUST PIPE
RM24M0E _51 Engine / Hybrid System _059549 2GR-FE EXHAUST _0291837 EXHAUST PIPE A

2GR-FE EXHAUST  EXHAUST PIPE  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

HINT:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See Page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 89465 2.REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

Hide 17430 3.REMOVE TAIL EXHAUST PIPE ASSEMBLY

a.
A160217

Remove the 2 bolts, 2 compression springs and tail exhaust pipe assembly.


b.

Remove the gasket from the No. 2 exhaust pipe sub-assembly.


Hide 17403A 4.REMOVE NO. 2 EXHAUST PIPE SUB-ASSEMBLY

a.
A160218

Remove the 2 bolts, 2 compression springs and No. 2 exhaust pipe sub-assembly.


b.

Remove the gasket from the center exhaust pipe assembly.


Hide 17420 5.REMOVE CENTER EXHAUST PIPE ASSEMBLY

a.
A160219

Remove the 2 bolts, 2 nuts and center exhaust pipe assembly.


b.

Remove the 2 gaskets from the center exhaust pipe assembly.


Hide 17584B 6.REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET

a.

Disconnect the heated oxygen sensor (for bank 2 sensor 2) connector.


b.
A160220

Remove the 2 bolts and No. 1 exhaust pipe support bracket.


Hide 17410 7.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.
A160221

Remove the 2 nuts and front exhaust pipe assembly.


b.

Remove the gasket from the front exhaust pipe assembly.


Hide 89465A 8.REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)