Home › Engine / Hybrid System › 2GR-FE LUBRICATION › OIL PUMP
RM24M0E _51 Engine / Hybrid System _059553 2GR-FE LUBRICATION _0291858 OIL PUMP A

2GR-FE LUBRICATION  OIL PUMP  REMOVAL  


PROCEDURE

Hide 1.REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

Hide 11201 8.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY (for Bank 1)

Hide 11202 9.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY (for Bank 2)

Hide 11302 13.REMOVE TIMING CHAIN COVER SUB-ASSEMBLY

a.
A128004

Remove the 23 bolts and 2 nuts as shown in the illustration.


b.
A129690E14
0.5,3.969 1.344,4.292 1.344,4.292 2.938,3.979 false 1.969,0.552 0.74,2.052 0.74,2.052 0.729,1.125 false 2.406,0.938 0.729,2.073 false 0.135,2.094 1.135,2.427 1,0.333 10 true Protective Tape 1.052,4.313 2.052,4.646 1,0.333 10 false Protective Tape

Remove the timing chain cover by prying between the timing chain cover and cylinder head or cylinder block with a screwdriver.

NOTICE:

Be careful not to damage the contact surfaces of the cylinder head, cylinder block and chain cover.


HINT:

Tape the screwdriver tip before use.



c.
U113567

Remove the gasket.


Hide 11301C 14.REMOVE TIMING CHAIN CASE OIL SEAL

a.
A128007E14
1.573,0.865 1.302,0.167 false 1.958,1.104 0.927,1.604 false 0.25,0.063 1.26,0.292 1.01,0.229 10 true Protective Tape 0.292,1.625 1.365,1.875 1.073,0.25 10 true Wooden Block

Using a screwdriver, pry out the oil seal.

HINT:

Tape the screwdriver tip before use.