Home › Drivetrain › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM › from 2016.05
RM24M0E _52 Drivetrain _059557 TIRE AND WHEEL _0291871 TIRE PRESSURE WARNING SYSTEM J

TIRE AND WHEEL  TIRE PRESSURE WARNING SYSTEM  ECU Power Source Circuit  


DESCRIPTION

The IG circuit is the power source for the tire pressure warning ECU and receiver.

WIRING DIAGRAM

C270968E51
4.583,1.771 5.5,2.073 0.917,0.302 10 false M44 4.583,1.948 6.292,2.406 1.708,0.458 10 false Tire Pressure Warning ECU and Receiver 5.031,0.615 5.25,0.875 0.219,0.26 10 false IG 5.031,1.156 5.406,1.365 0.375,0.208 10 false GND 4.833,0.51 4.979,0.76 0.146,0.25 10 false 1 4.771,1.042 4.958,1.26 0.188,0.219 10 false 12 3.229,0.813 4.469,1.063 1.24,0.25 10 false LH ECU-IG 0.938,0.635 1.896,0.875 0.958,0.24 10 false from IG Circuit

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

·

It is necessary to perform initialization (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.



HINT:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (ECU - BATTERY AND BODY GROUND)
a.
U189609E02
1.229,1.198 0.823,1.688 0.823,1.688 0.823,1.802 false 2.198,1.354 2.625,1.26 2.625,1.26 2.74,1.26 false 0.354,1.125 0.667,1.292 0.313,0.167 10 false M44 0.125,0.073 0.333,0.26 0.208,0.188 10 false *a 0.75,1.823 0.969,2.021 0.219,0.198 10 false IG 2.792,1.177 3.135,1.344 0.344,0.167 10 false GND

Disconnect the M44 tire pressure warning ECU and receiver connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
M44-1 (IG) - Body ground Engine switch on (IG) 10 to 16 V
Engine switch off Below 1 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
M44-12 (GND) - Body ground Always Below 1 Ω



Text in Illustration
*a Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)


OK

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR