Home › Drivetrain › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM › from 2016.05
RM24M0E _52 Drivetrain _059557 TIRE AND WHEEL _0291871 TIRE PRESSURE WARNING SYSTEM J

TIRE AND WHEEL  TIRE PRESSURE WARNING SYSTEM  Tire Pressure Warning Light Circuit  


DESCRIPTION

If the tire pressure warning ECU and receiver detects any problems, the tire pressure warning light blinks for 1 minute then illuminates, and tire pressure monitoring is disabled at the same time. At this time, the ECU stores a DTC in memory.

Connecting terminals TC and CG of the DLC3 makes the tire pressure warning light blink to output DTCs.

WIRING DIAGRAM

C287874E11
0.604,2.438 1.031,2.635 0.427,0.198 10 false G28 0.594,2.604 3.25,2.771 2.656,0.167 10 false Combination Meter Sub-assembly 1.323,1.458 2,1.615 0.677,0.156 10 false TIRE 5.646,1.448 6.063,1.604 0.417,0.156 10 false IND 1.781,1.333 2.042,1.479 0.26,0.146 10 false 36 5.438,1.344 5.635,1.51 0.198,0.167 10 false 5 5.229,2.552 6.969,3.021 1.74,0.469 10 false Tire Pressure Warning ECU and Receiver 5.229,2.385 5.625,2.542 0.396,0.156 10 false M44

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

·

It is necessary to perform initialization (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.



PROCEDURE

1.CHECK OPERATION OF TIRE PRESSURE WARNING LIGHT (ACTIVE TEST)
a.

Turn the engine switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the engine switch on (IG).


d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


f.

Check the condition of the tire pressure warning light using the GTS.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Indicat. Tire Pressure Warning System Tire pressure warning light OFF or ON -

OK:

The tire pressure warning light turns on or off in accordance with the GTS operation.




OK

2.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU AND RECEIVER - COMBINATION METER SUB-ASSEMBLY)

NG

2.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU AND RECEIVER - COMBINATION METER SUB-ASSEMBLY)
a.

Disconnect the G28 combination meter sub-assembly connector.


b.

Disconnect the M44 tire pressure warning ECU and receiver connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
M44-5 (IND) - G28-36 (TIRE) Always Below 1 Ω
M44-5 (IND) or G28-36 (TIRE) - Body ground Always 10 kΩ or higher




OK

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR