CHECK DTC (for TIRE PRESSURE WARNING ECU AND RECEIVER) (USING GTS)
Turn the engine switch off.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
Read the DTCs.
CHECK DTC (for TIRE PRESSURE WARNING ECU AND RECEIVER) (USING SST CHECK WIRE)
Turn the engine switch off.
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
Turn the engine switch on (IG).
Read and record any DTCs indicated by the tire pressure warning light in the combination meter sub-assembly. Refer to the illustration for examples of a normal system code and codes 13 and 33.
If 2 or more malfunctions are indicated at the same time, the lowest numbered DTC is displayed first.
| *1 | DLC3 |
| *2 | Tire Pressure Warning Light |
| *a | Normal System Code |
| *b | ON |
| *c | OFF |
| *d | 0.25 sec. |
| *e | Code 13 and 33 |
| *f | 0.5 sec. |
| *g | 2.5 sec. |
| *h | 1.5 sec. |
| *i | 4.5 sec. |
| *j | Repeat |
Refer to Diagnostic Trouble Code Chart (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>DIAGNOSTIC TROUBLE CODE CHART) for DTC information.
After completing the check, turn the engine switch off and remove SST from the DLC3.
CLEAR DTC (for TIRE PRESSURE WARNING ECU AND RECEIVER)
After repairing the malfunctions, clear the DTCs.
Turn the engine switch off.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
Clear the DTCs following the prompts on the GTS screen.
Refer to the GTS operator's manual for further details.