Home › Brake › BRAKE › REAR BRAKE FLEXIBLE HOSE
RM24M0E _54 Brake _059558 BRAKE _0291880 REAR BRAKE FLEXIBLE HOSE A

BRAKE  REAR BRAKE FLEXIBLE HOSE  REMOVAL  


PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 2.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 47319F 3.REMOVE REAR FLEXIBLE HOSE LH

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



a.
C133742E05
1.885,0 2.052,0.188 0.167,0.188 10 false B 0.406,1.781 0.573,1.969 0.167,0.188 10 false C 2.552,0.698 2.719,0.885 0.167,0.188 11 true A

Using SST, disconnect the brake tube (labeled A) from the flexible hose while holding the flexible hose with a wrench.

SST
09023-00101  

NOTICE:
·

Do not bend or damage the brake tube.

·

Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.




b.

Remove the clip (labeled B).


c.

Remove the union bolt (labeled C) and gasket, and then remove the flexible hose from the disc brake cylinder.


Hide 47321B 4.REMOVE REAR BRAKE TUBE FLEXIBLE HOSE

a.

for RH:

Remove the tailpipe and front floor No. 2 heat insulator (for 2AZ-FE: see page Engine / Hybrid System>2AZ-FE EXHAUST>EXHAUST PIPE>REMOVAL, for 2GR-FE: see page Engine / Hybrid System>2GR-FE EXHAUST>EXHAUST PIPE>REMOVAL).


b.

Using SST, disconnect the brake tubes (labeled A, B) from the flexible hose while holding the flexible hose with a wrench.

C364206E02
2.26,0.865 2.479,1.042 0.219,0.177 10 false A 0.208,0.146 0.865,0.396 0.656,0.25 10 false for LH: 3.677,0.115 4.177,0.344 0.5,0.229 10 false for RH: 2.51,1.198 2.729,1.375 0.219,0.177 10 true C 1.271,2.042 1.458,2.219 0.188,0.177 10 true B 1.469,1.885 1.625,2.042 0.156,0.156 10 true D 4.729,1.281 4.948,1.458 0.219,0.177 10 false A 4.979,1.271 5.198,1.448 0.219,0.177 10 false C 4.521,2.427 4.74,2.604 0.219,0.177 10 false B 4.792,2.365 5.01,2.542 0.219,0.177 10 false D

SST
09023-00101  

NOTICE:
·

Do not bend or damage the brake tube.

·

Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.




c.

Remove the clips (labeled C, D), and then remove the flexible hose.