Home › Brake › BRAKE › BRAKE BOOSTER(for 2AZ-FE LHD)
RM24M0E _54 Brake _059558 BRAKE _0291882 BRAKE BOOSTER(for 2AZ-FE LHD) A

BRAKE  BRAKE BOOSTER(for 2AZ-FE LHD)  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 74431 3.REMOVE BATTERY TRAY

Hide 17705 4.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 17700 5.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 6.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 47201 7.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

Hide 8.DISCONNECT VACUUM HOSE

Hide 47264A 9.REMOVE PUSH ROD PIN

a.

Remove the clip from the push rod pin.


b.

Remove the push rod pin from the push rod clevis.


Hide 47264D 10.REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS

a.

Loosen the push rod clevis lock nut.


b.

Remove the push rod clevis.


Hide 44610 11.REMOVE BRAKE BOOSTER ASSEMBLY

a.
C158086

Remove the 4 nuts.


b.

Pull out the booster with gasket.


Hide 44785 12.REMOVE BRAKE BOOSTER GASKET

Hide 44730 13.REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY

Hide 44696 14.REMOVE CHECK VALVE GROMMET