Home › Steering › POWER STEERING › POWER STEERING SYSTEM › from 2016.05
RM24M0E _55 Steering _059561 POWER STEERING _0291895 POWER STEERING SYSTEM L

POWER STEERING  POWER STEERING SYSTEM  PRECAUTION  


NOTICE FOR INITIALIZATION


NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.


System Name See procedure
Lighting System (w/ AFS) (Click here)
Parking Assist Monitor System
Power Slide Door System
Power Back Door System


HANDLING PRECAUTIONS FOR SRS AIRBAG SYSTEM


a.

The vehicle is equipped with an SRS (Supplemental Restraint System) such as airbags. Failure to carry out service operations in the correct sequence could cause the SRS to unexpectedly deploy during servicing. This may cause a serious accident.

Before servicing (including inspection, replacement, removal and installation of parts), be sure to read the precautionary notices for the Supplemental Restraint System (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).



PRECAUTIONS FOR REMOVAL, INSTALLATION AND REPLACEMENT OF ELECTRONIC MOTOR POWER STEERING COMPONENTS


a.

Be sure to align the front wheels straight ahead when removing and installing the power steering gear assembly.


b.

If disconnecting the steering sliding yoke sub-assembly and the pinion shaft of the power steering gear assembly, be sure to place matchmarks before starting the operation.


c.

After replacing the power steering gear assembly or power steering ECU, clear the rotation angle sensor calibration value, initialize the rotation angle sensor, and calibrate the torque sensor zero point (See page Steering>POWER STEERING>POWER STEERING SYSTEM>CALIBRATION).