These DTCs do not indicate a malfunction. The power steering ECU outputs these DTCs when it determines that the rotation angle sensor value initialization and torque sensor zero point calibration are incomplete.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1516 | Torque sensor zero point calibration is incomplete due to the steering wheel being touched during calibration. | There is no malfunction if this DTC is not output again after clearing the DTCs and torque sensor calibration value, and performing zero point calibration. |
| C1526 | Rotation angle sensor value initialization is incomplete due to the steering wheel being touched during calibration. | There is no malfunction if this DTC is not output again after clearing the DTCs and torque sensor calibration value, and performing rotation angle sensor value initialization. |
If the steering column or power steering ECU has been replaced, perform the rotation angle sensor initialization and torque sensor zero point calibration (see page Steering>POWER STEERING>POWER STEERING SYSTEM>CALIBRATION).
Clear the DTCs (see page Steering>POWER STEERING>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
NEXT
Initialize the rotation angle sensor value and calibrate the torque sensor zero point (see page Steering>POWER STEERING>POWER STEERING SYSTEM>CALIBRATION).
NEXT
Check for DTCs (see page Steering>POWER STEERING>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
| Condition | Proceed to |
|---|---|
| DTCs are still output after performing rotation angle sensor value initialization and steering zero point calibration 3 times. | A |
| DTCs are still output even after performing rotation angle sensor value initialization and steering zero point calibration once or twice. | B |
| Normal system code is output. | C |
Replace the power steering ECU if DTCs are still output after performing rotation angle sensor value initialization and steering zero point calibration 3 times.
A
B
C
Replace the power steering ECU (for LHD) (see page Steering>POWER STEERING>POWER STEERING ECU(for LHD)>REMOVAL).
Replace the power steering ECU (for RHD) (see page Steering>POWER STEERING>POWER STEERING ECU(for RHD)>REMOVAL).
NEXT
Clear the DTCs (see page Steering>POWER STEERING>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
NEXT
Initialize the rotation angle sensor value and calibrate the torque sensor zero point (see page Steering>POWER STEERING>POWER STEERING SYSTEM>CALIBRATION).
NEXT
Check for DTCs (see page Steering>POWER STEERING>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
| Condition | Proceed to |
|---|---|
| DTCs are still output after performing rotation angle sensor value initialization and steering zero point calibration 3 times. | A |
| DTCs are still output even after performing rotation angle sensor value initialization and steering zero point calibration once or twice. | B |
| Normal system code is output. | C |
Replace the power steering if DTCs are still output after performing rotation angle sensor value initialization and steering zero point calibration 3 times.
If replacing the power steering, clear the rotation angle sensor calibration value, initialize the rotation angle sensor value, and calibrate the torque sensor zero point (see page Steering>POWER STEERING>POWER STEERING SYSTEM>CALIBRATION).
A
B
C