The power steering ECU receives vehicle speed signals from the skid control ECU via CAN communication. The ECU provides appropriate assisting force in accordance with the vehicle speed, based on the signals.
If the ECU detects this DTC, it adjusts the amount of power assistance for a speed of 100 km/h (62 mph) and continues the system control.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1541 | This DTC is detected when vehicle speed signals via CAN communication are cut off for 3 seconds or more. | ·
Speed sensor circuit ·
Skid control ECU ·
CAN communication system ·
Power steering ECU |
If the steering column or power steering ECU has been replaced, perform the rotation angle sensor initialization and torque sensor zero point calibration (see page Steering>POWER STEERING>POWER STEERING SYSTEM>CALIBRATION).
Check if DTC U0129 is output.
| DTC Condition | Proceed to |
|---|---|
| No output | A |
| U0129 is output | B |
DTC U0129 indicates a skid control ECU communication malfunction in the electric power steering system.
A
B
Check for DTCs of the ABS & VSC system.
| DTC Condition | Proceed to |
|---|---|
| No output | A |
| C0200, C0205, C0210 or C0215 is output (without VSC) | B |
| C0200, C0205, C0210 or C0215 is output (with VSC) | C |
These DTCs indicate a speed sensor signal malfunction in the ABS & VSC system.
If replacing the power steering ECU, initialize the rotation angle sensor and calibrate the torque sensor zero point (see page Steering>POWER STEERING>POWER STEERING SYSTEM>CALIBRATION).
A
B
(See pageBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DIAGNOSTIC TROUBLE CODE CHART)
C