Home › Steering › POWER STEERING › POWER STEERING SYSTEM › from 2016.05
RM24M0E _55 Steering _059561 POWER STEERING _0291895 POWER STEERING SYSTEM C

POWER STEERING  POWER STEERING SYSTEM  C1582  Assist Map Number Mismatch  


DESCRIPTION

When an incorrect ECM or an incorrect skid control ECU (brake actuator assembly) is installed after the assist map has been recorded in the power steering ECU, then DTC C1582 is stored because the data does not match the vehicle specifications.

DTC No. DTC Detection Condition Trouble Area
C1582 Assist map number mismatch
·

Power steering ECU

·

CAN communication system

·

ECM

·

Skid control ECU (brake actuator assembly)



CAUTION / NOTICE / HINT

NOTICE:

If the steering column or power steering ECU has been replaced, perform the rotation angle sensor initialization and torque sensor zero point calibration (See page Steering>POWER STEERING>POWER STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
a.

Using the intelligent tester, check for DTCs and confirm that there are no problems in the CAN communication system (See page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).

OK:

DTC is not output.




OK

2.CHECK ECM

NG

2.CHECK ECM
a.

Check if an ECM that complies with the vehicle specifications is installed.

OK:

The ECM that complies with vehicle specifications is installed.




OK

3.CHECK SKID CONTROL ECU

NG

REPLACE ECM

3.CHECK SKID CONTROL ECU
a.

Check if a skid control ECU (brake actuator assembly) that complies with the vehicle specifications is installed.

OK:

The skid control ECU (brake actuator assembly) that complies with vehicle specifications is installed.




OK

REPLACE POWER STEERING ECU

NG