Home › Steering › POWER STEERING › POWER STEERING ECU(for RHD) › 2013.04–2016.05
RM24M0E _55 Steering _059561 POWER STEERING _0291896 POWER STEERING ECU(for RHD) A

POWER STEERING  POWER STEERING ECU(for RHD)  INSTALLATION  


PROCEDURE

Hide 89650 1.INSTALL POWER STEERING ECU

a.
C136581

Install the ECU with the 2 nuts.

NOTICE:

Do not drop or strike the power steering ECU. If dropped or struck, replace it with a new one.


Torque:
13 N*m (138 kgf*cm, 10 ft.*lbf)


b.
C136586

Install the 4 ECU connectors.


c.
C136580

Install the bolt to the ECU bracket.

Torque:
13 N*m (138 kgf*cm, 10 ft.*lbf)


Hide 55432B 2.INSTALL INSTRUMENT PANEL FINISH PANEL LOWER

a.

Install instrument panel finish panel lower (see page Vehicle Interior>INTERIOR PANEL>LOWER INSTRUMENT PANEL>INSTALLATION).


Hide 28800 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 4. PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.