The side collision sensor LH circuit (bus 1) consists of the center airbag sensor assembly, side airbag sensor LH (for Front Side), side airbag sensor LH (for Rear Side) and rear airbag sensor LH.
The side airbag sensor LH (for Front Side), side airbag sensor LH (for Rear Side) and rear airbag sensor LH detect impacts to the vehicle and send signals to the center airbag sensor assembly to determine if the airbags should be deployed.
DTC B1635/24 is stored when a malfunction is detected in the rear airbag sensor LH.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1635/24 | ·
Rear airbag sensor LH malfunction ·
Center airbag sensor assembly malfunction |
·
Rear airbag sensor LH ·
Center airbag sensor assembly |
Refer to DTCs B1627/82, B1628/82, B1637/82, B1638/82, B1647/82, B1648/82, B1684/82 and B1689/82 (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>B1627/82).
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Turn the engine switch off.
Disconnect the cable from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Interchange the rear airbag sensor LH with RH and connect the connectors to them.
Connect the cable to the negative (-) battery terminal.
Clear the DTCs stored in memory (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
Turn the engine switch off.
Turn the engine switch on (IG), and wait for at least 60 seconds.
Check for DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC B1635/24 is output. | A |
| DTC B1630/23 is output. | B |
| DTCs B1630/23 and B1635/24 are not output. | C |
Codes other than DTCs B1630/23 and B1635/24 may be output at this time, but they are not related to this check.
Turn the engine switch off.
Disconnect the cable from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Return the rear airbag sensor LH and RH to their original positions and connect the connectors.
| *1 | Rear Airbag Sensor RH |
| *2 | Side Airbag Sensor LH (for Front Side) |
A
B
C
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)