The side collision sensor RH circuit (bus 1) consists of the center airbag sensor assembly, side airbag sensor RH (for Front Side), side airbag sensor RH (for Rear Side) and rear airbag sensor RH.
The side airbag sensor RH (for Front Side), side airbag sensor RH (for Rear Side) and rear airbag sensor RH detect impacts to the vehicle and send signals to the center airbag sensor assembly to determine if the airbags should be deployed.
DTC B1657/95 is stored when a malfunction is detected in the side airbag sensor RH (for Rear Side).
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1657/95 | ·
Side airbag sensor RH (for Rear Side) malfunction ·
Center airbag sensor assembly malfunction |
·
Side airbag sensor RH (for Rear Side) ·
Center airbag sensor assembly |
Refer to DTCs B1622/81, B1623/81, B1632/81, B1633/81, B1642/81, B1643/81, B1673/81 and B1674/81 (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>B1622/81).
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Turn the engine switch off.
Disconnect the cable from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Interchange the side airbag sensor RH (for Rear Side) with LH (for Rear Side) and connect the connectors.
Connect the cable to the negative (-) battery terminal.
Clear the DTCs stored in memory (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
Turn the engine switch off.
Turn the engine switch on (IG), and wait for at least 60 seconds.
Check for DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC B1657/95 is output. | A |
| DTC B1672/96 is output. | B |
| DTC B1657/95 and B1672/96 are not output. | C |
Codes other than DTC B1657/95 and B1672/96 may be output at this time, but they are not related to this check.
Turn the engine switch off.
Disconnect the cable from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Return the side airbag sensor RH (for Rear Side) and LH (for Rear Side) to their original positions and connect the connectors.
| *1 | Side Airbag Sensor LH (for Rear Side) |
| *2 | Rear Airbag Sensor RH |
A
B
C
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)