Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › from 2016.05
RM24M0E _58 Vehicle Interior _059562 SUPPLEMENTAL RESTRAINT SYSTEMS _0291898 AIRBAG SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  B1672/96  Rear Door Side Airbag Sensor LH Malfunction  


DESCRIPTION

The side collision sensor LH circuit (bus 1) consists of the center airbag sensor assembly, side airbag sensor LH (for Front Side), side airbag sensor LH (for Rear Side) and rear airbag sensor LH.

The side airbag sensor LH (for Front Side), side airbag sensor LH (for Rear Side) and rear airbag sensor LH detect impacts to the vehicle and send signals to the center airbag sensor assembly to determine if the airbag should be deployed.

DTC B1672/96 is stored when a malfunction is detected in the side airbag sensor LH (for Rear Side).

DTC No. DTC Detection Condition Trouble Area
B1672/96
·

Side airbag sensor LH (for Rear Side) malfunction

·

Center airbag sensor assembly malfunction


·

Side airbag sensor LH (for Rear Side)

·

Center airbag sensor assembly



WIRING DIAGRAM

Refer to DTCs B1627/82, B1628/82, B1637/82, B1638/82, B1647/82, B1648/82, B1684/82 and B1689/82 (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>B1627/82).

CAUTION / NOTICE / HINT

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


PROCEDURE

1.CHECK SIDE AIRBAG SENSOR LH (for Rear Side)
a.
C238395E09
0.698,0.938 0.875,1.115 0.177,0.177 10 false *1 2.552,0.938 2.729,1.115 0.177,0.177 10 false *2 2.25,0.99 2.375,1.188 0.125,0.198 10 false A 2.094,0.99 2.219,1.188 0.125,0.198 10 false B 1.74,0.99 1.865,1.188 0.125,0.198 10 false C 1.583,0.99 1.708,1.188 0.125,0.198 10 false D 1.25,1 1.375,1.198 0.125,0.198 10 false E 1.094,1 1.219,1.198 0.125,0.198 10 false F

Turn the engine switch off.


b.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Interchange the side airbag sensor LH (for Rear Side) with RH (for Rear Side) and connect the connectors.


d.

Connect the cable to the negative (-) battery terminal.



f.

Turn the engine switch off.


g.

Turn the engine switch on (IG), and wait for at least 60 seconds.


h.

Check for DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC B1672/96 is output. A
DTC B1657/95 is output. B
DTC B1657/95 and B1672/96 are not output. C


HINT:

Codes other than DTC B1657/95 and B1672/96 may be output at this time, but they are not related to this check.



i.

Turn the engine switch off.


j.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



k.

Return the side airbag sensor LH (for Rear Side) and RH (for Rear Side) to their original positions and connect the connectors.

Text in Illustration
*1 Side Airbag Sensor RH (for Rear Side)
*2 Rear Airbag Sensor LH



A

B

C