Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD › 2013.04–2016.05
RM24M0E _58 Vehicle Interior _059562 SUPPLEMENTAL RESTRAINT SYSTEMS _0291899 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

Hide 45130 1.INSTALL STEERING PAD ASSEMBLY

a.
C136810

Support the steering pad with one hand as shown in the illustration.


b.

Connect the airbag connector.

NOTICE:

When handling the airbag connector, do not damage the airbag wire harness.



c.

Connect the horn connector.


d.

Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.


e.
C140955E02
1.302,0.604 1.302,1.177 true 1.302,1.188 1.469,1.188 true 1.49,1.104 2.271,1.427 0.781,0.323 10 true Screw Case

Using a T30 "TORX" socket, install the 2 screws.

Torque:
8.8 N*m (90 kgf*cm, 78 in.*lbf)


Hide 28800 2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 45186 3.INSTALL NO. 2 STEERING WHEEL LOWER COVER

a.
C139023

Install the cover to attach the 2 claws.


Hide 45187 4.INSTALL NO. 3 STEERING WHEEL LOWER COVER

a.

Use the same procedures for the No. 3 steering wheel lower cover and No. 2 steering wheel lower cover.


Hide 45130 5.INSPECT STEERING PAD ASSEMBLY

a.

Check for cuts, cracks or discoloration on the steering pad outer surface and in the grooved portion.


b.

Check that the horn sounds.


Hide 6.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



Hide 7.CHECK SRS WARNING LIGHT