Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY › 2013.04–2016.05
RM24M0E _58 Vehicle Interior _059562 SUPPLEMENTAL RESTRAINT SYSTEMS _0291903 CURTAIN SHIELD AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CURTAIN SHIELD AIRBAG ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.



CAUTION:

Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

Hide 28800 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 63310 2.REMOVE ROOF HEADLINING ASSEMBLY

a.

Remove the roof headlining (see page Vehicle Interior>INTERIOR>ROOF HEADLINING>REMOVAL).


Hide 62180A 3.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

C136835

a.

Disconnect the 2 connectors.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



b.

Remove the 10 bolts and 3 clips.


c.

Remove the curtain shield airbag.