Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
1.INSTALL CENTER FLOOR AIRBAG SENSOR
Install the clip.
Install the sensor with the bolt.
If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
Check that there is no looseness in the installation parts of the sensor.
Connect the sensor connector.
2.INSTALL CENTER FLOOR AIRBAG SENSOR COVER
Attach the 2 claws to install the sensor cover.
3.INSTALL FRONT SEAT ASSEMBLY LH
for Manual Seat:
Install the front seat (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>INSTALLATION).
for Power Seat:
Install the front seat (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>INSTALLATION).
28800
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5.PERFORM INITIALIZATION
Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
6.CHECK SRS WARNING LIGHT
Check the SRS warning light (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).