Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
45130
1.INSTALL STEERING PAD ASSEMBLY
Support the steering pad with one hand as shown in the illustration.
Connect the airbag connector.
When handling the airbag connector, do not damage the airbag wire harness.
Connect the horn connector.
Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.
Using a T30 "TORX" socket, install the 2 screws.
28800
2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
45186
3.INSTALL NO. 2 STEERING WHEEL LOWER COVER
Install the cover to attach the 2 claws.
45187
4.INSTALL NO. 3 STEERING WHEEL LOWER COVER
Use the same procedures for the No. 3 steering wheel lower cover and No. 2 steering wheel lower cover.
45130
5.INSPECT STEERING PAD ASSEMBLY
Check for cuts, cracks or discoloration on the steering pad outer surface and in the grooved portion.
Check that the horn sounds.
6.PERFORM INITIALIZATION
Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
7.CHECK SRS WARNING LIGHT
Check the SRS warning light (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).