Use the same procedures for the RH and LH side.
The procedures listed below are for the LH side.
81590A
1.INSTALL REAR LIGHT ASSEMBLY LH
Attach the pin to install the rear light.
Install the 3 nuts.
Connect the connector.
84280D
2.INSTALL POWER BACK DOOR SENSOR ASSEMBLY LH
67750
3.INSTALL BACK DOOR TRIM BOARD ASSEMBLY
62581H
4.INSTALL REAR WINDOW SIDE GARNISH RH
62582H
5.INSTALL REAR WINDOW SIDE GARNISH LH
67848
6.INSTALL BACK DOOR SERVICE HOLE COVER LH (for Power Back Door)
67939D
7.INSTALL BACK DOOR GARNISH CENTER
81560
8.INSTALL REAR COMBINATION LIGHT ASSEMBLY LH
Connect the connector.
Attach the clip to install the light.
Install the 2 screws.
9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10.PERFORM INITIALIZATION
Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.