Home › Vehicle Interior › LIGHTING › REAR COMBINATION LIGHT ASSEMBLY(except LED Headlight) › from 2016.05
RM24M0E _58 Vehicle Interior _059564 LIGHTING _0291937 REAR COMBINATION LIGHT ASSEMBLY(except LED Headlight) A

LIGHTING  REAR COMBINATION LIGHT ASSEMBLY(except LED Headlight)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH and LH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 81590A 1.INSTALL REAR LIGHT ASSEMBLY LH

B146707E01
0.595,3.158 1.017,3.325 0.423,0.167 10 Clamp

a.

Attach the pin to install the rear light.


b.
E130641

Install the 3 nuts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


c.

Connect the connector.


Hide 84280D 2.INSTALL POWER BACK DOOR SENSOR ASSEMBLY LH

Hide 67750 3.INSTALL BACK DOOR TRIM BOARD ASSEMBLY

Hide 62581H 4.INSTALL REAR WINDOW SIDE GARNISH RH

Hide 62582H 5.INSTALL REAR WINDOW SIDE GARNISH LH

Hide 67848 6.INSTALL BACK DOOR SERVICE HOLE COVER LH (for Power Back Door)

Hide 67939D 7.INSTALL BACK DOOR GARNISH CENTER

Hide 81560 8.INSTALL REAR COMBINATION LIGHT ASSEMBLY LH

B457200

a.

Connect the connector.


b.

Attach the clip to install the light.


c.

Install the 2 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 10.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.