Use the same procedures for the RH and LH side.
The procedures listed below are for the LH side.
81080G
1.INSTALL REAR DOOR INSIDE HANDLE ILLUMINATION LIGHT ASSEMBLY LH
Turn the rear door inside handle illumination in the direction indicated by the arrow to install it.
Attach the clamp.
67604
2.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
81080E
3.INSTALL FRONT DOOR INSIDE HANDLE ILLUMINATION LIGHT ASSEMBLY LH
Turn the front door inside handle illumination in the direction indicated by the arrow to install it.
Attach the clamp.
67602
4.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
69278B
5.INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH
67492A
6.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH
7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8.PERFORM INITIALIZATION
Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.