Home › Vehicle Interior › LIGHTING › LIGHTING SYSTEM(for LED Headlight) › from 2016.05
RM24M0E _58 Vehicle Interior _059564 LIGHTING _0291968 LIGHTING SYSTEM(for LED Headlight) J

LIGHTING  LIGHTING SYSTEM(for LED Headlight)  Hazard Warning Switch Circuit  


DESCRIPTION

The combination meter assembly receives the hazard warning signal switch ON signal and controls the operation of the hazard warning lights.

WIRING DIAGRAM

E224262E23
1.542,0.854 1.76,1.052 0.219,0.198 10 false 1 2.948,0.844 3.229,1.146 0.281,0.302 10 false 4 4.813,0.844 5.094,1.115 0.281,0.271 10 false 5 5.01,0.958 5.521,1.24 0.51,0.281 10 false HAZ 4.469,1.469 4.865,1.75 0.396,0.281 10 false G123 4.479,1.656 6.406,2.125 1.927,0.469 10 false Combination Meter Assembly 1.438,1.458 1.76,1.667 0.323,0.208 10 false P1 1.438,1.615 3.188,1.979 1.75,0.365 10 false Hazard Warning Signal Switch Assembly

PROCEDURE

1.READ VALUE USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Data List.


e.

Read the Data List according to the display on the GTS.

Combination Meter
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Hazard Flasher Switch Hazard warning signal switch signal/ON or OFF ON: Hazard warning signal switch on
OFF: Hazard warning signal switch off
-

OK:

Normal conditions listed above are displayed.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY
2.INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY
a.

Remove the hazard warning signal switch assembly (See page Vehicle Interior>LIGHTING>HAZARD WARNING SWITCH>REMOVAL).


b.

Inspect the hazard warning signal switch assembly (See page Vehicle Interior>LIGHTING>HAZARD WARNING SWITCH>INSPECTION).



OK

3.CHECK HARNESS AND CONNECTOR (HAZARD WARNING SIGNAL SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY)

NG

REPLACE HAZARD WARNING SIGNAL SWITCH ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (HAZARD WARNING SIGNAL SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY)
a.

Disconnect the G123 combination meter assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
P1-4 - G123-5 (HAZ) Always Below 1 Ω
P1-4 or G123-5 (HAZ) - Body ground Always 10 kΩ or higher
P1-1 - Body ground Always Below 1 Ω




OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR