Home › Vehicle Interior › LIGHTING › LIGHTING SYSTEM(for LED Headlight) › from 2016.05
RM24M0E _58 Vehicle Interior _059564 LIGHTING _0291968 LIGHTING SYSTEM(for LED Headlight) J

LIGHTING  LIGHTING SYSTEM(for LED Headlight)  Headlight Beam Level Control Actuator Circuit  


DESCRIPTION

The headlight leveling ECU assembly actuates the headlight leveling motors according to vehicle conditions.

WIRING DIAGRAM

E349359E03
4.677,5.073 5.135,5.271 0.458,0.198 10 false A39 4.656,5.24 7.156,5.5 2.5,0.26 10 false Headlight Leveling ECU Assembly 5.25,0.719 5.708,0.917 0.458,0.198 10 false 10 5.26,1 5.719,1.198 0.458,0.198 10 false 23 5.26,1.292 5.719,1.49 0.458,0.198 10 false 17 5.26,3.438 5.719,3.635 0.458,0.198 10 false 11 5.26,3.75 5.719,3.948 0.458,0.198 10 false 24 5.26,4.031 5.719,4.229 0.458,0.198 10 false 18 5.49,0.802 5.948,1 0.458,0.198 10 false LR1+ 5.5,1.104 5.958,1.302 0.458,0.198 10 false LR1- 5.49,4.125 5.948,4.323 0.458,0.198 10 false LHT 5.479,3.563 5.938,3.76 0.458,0.198 10 false LL1+ 5.479,3.854 5.938,4.052 0.458,0.198 10 false LL1- 3.167,0.708 3.625,0.906 0.458,0.198 10 false 6 3.177,1.01 3.635,1.208 0.458,0.198 10 false 1 3.146,4.042 3.604,4.24 0.458,0.198 10 false 5 3.146,3.469 3.604,3.667 0.458,0.198 10 false 6 3.146,3.781 3.604,3.979 0.458,0.198 10 false 1 3.167,1.271 3.625,1.469 0.458,0.198 10 false 5 5.5,1.406 5.958,1.604 0.458,0.198 10 false RHT 2.75,0.719 3.208,0.917 0.458,0.198 10 false RHIG 2.76,1.01 3.219,1.208 0.458,0.198 10 false RH E 2.76,1.302 3.219,1.5 0.458,0.198 10 false RH T 2.781,3.458 3.24,3.656 0.458,0.198 10 false LHIG 2.792,3.771 3.25,3.969 0.458,0.198 10 false LH E 2.781,4.042 3.24,4.24 0.458,0.198 10 false LH T 0.646,2.302 1.104,2.5 0.458,0.198 10 false B30 0.625,5.052 1.083,5.25 0.458,0.198 10 false B31 0.958,2.302 3.458,2.563 2.5,0.26 10 false Headlight Assembly RH 0.948,5.052 3.448,5.313 2.5,0.26 10 false Headlight Assembly LH 0.875,1.854 3.375,2.115 2.5,0.26 10 false Headlight Leveling Motor RH 0.823,4.604 3.323,4.865 2.5,0.26 10 false Headlight Leveling Motor LH 2.427,0.729 2.885,0.927 0.458,0.198 10 false 3 2.427,0.99 2.885,1.188 0.458,0.198 10 false 1 2.427,1.292 2.885,1.49 0.458,0.198 10 false 2 2.448,3.469 2.906,3.667 0.458,0.198 10 false 3 2.448,3.781 2.906,3.979 0.458,0.198 10 false 1 2.448,4.052 2.906,4.25 0.458,0.198 10 false 2

PROCEDURE

1.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Start the engine.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / HL AutoLeveling / Active Test.


e.

Perform the Active Test according to the display on the GTS.

HL AutoLeveling
Tester Display Test Part Control Range Diagnostic Note
Drive The Leveling Motor Leveling motor operation Up/Down/Stop Perform the active test with the engine running

OK:

Headlight leveling motors operate normally.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.CHECK HARNESS AND CONNECTOR (HEADLIGHT ASSEMBLY - HEADLIGHT LEVELING ECU ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (HEADLIGHT ASSEMBLY - HEADLIGHT LEVELING ECU ASSEMBLY)
a.

Disconnect the A39 headlight leveling ECU assembly connector.


b.

Disconnect the B30 or B31 headlight leveling motor connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
LH Side
Tester Connection Condition Specified Condition
A39-18 (LHT) - B31-5 (LH T) Always Below 1 Ω
A39-11 (LL1+) - B31-6 (LHIG) Always Below 1 Ω
A39-24 (LL1-) - B31-1 (LH E) Always Below 1 Ω
B31-5 (LH T) or A39-18 (LHT) - Body ground Always 10 kΩ or higher
B31-6 (LHIG) or A39-11 (LL1+) - Body ground Always 10 kΩ or higher
B31-1 (LH E) or A39-24 (LL1-) - Body ground Always 10 kΩ or higher

RH Side
Tester Connection Condition Specified Condition
A39-17 (RHT) - B30-5 (RH T) Always Below 1 Ω
A39-10 (LR1+) - B30-6 (RHIG) Always Below 1 Ω
A39-23 (LR1-) - B30-1 (RH E) Always Below 1 Ω
B30-5 (RH T) or A39-17 (RHT) - Body ground Always 10 kΩ or higher
B30-6 (RHIG) or A39-10 (LR1+) - Body ground Always 10 kΩ or higher
B30-1 (RH E) or A39-23 (LR1-) - Body ground Always 10 kΩ or higher




OK

3.INSPECT HEADLIGHT CORD

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT HEADLIGHT CORD
a.

Remove the headlight code from the headlight assembly (See page Vehicle Interior>LIGHTING>HEADLIGHT ASSEMBLY(for LED Headlight)>REMOVAL).




OK

4.REPLACE HEADLIGHT LEVELING MOTOR

NG

REPLACE HEADLIGHT CORD

4.REPLACE HEADLIGHT LEVELING MOTOR
a.

Replace the headlight leveling motor with a new or known good one (See page Vehicle Interior>LIGHTING>HEADLIGHT ASSEMBLY(for LED Headlight)>REMOVAL).



NEXT

5.PERFORM ACTIVE TEST USING GTS
5.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Start the engine.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / HL AutoLeveling / Active Test.


e.

Perform the Active Test according to the display on the GTS.

HL AutoLeveling
Tester Display Test Part Control Range Diagnostic Note
Drive The Leveling Motor Leveling motor operation Up/Down/Stop Perform the active test with the engine running

OK:

Headlight leveling motors operate normally.




OK

END (HEADLIGHT LEVELING MOTOR WAS DEFECTIVE)

NG

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY