Home › Vehicle Interior › LIGHTING › LIGHTING SYSTEM(for LED Headlight) › from 2016.05
RM24M0E _58 Vehicle Interior _059564 LIGHTING _0291968 LIGHTING SYSTEM(for LED Headlight) C

LIGHTING  LIGHTING SYSTEM(for LED Headlight)  B2452  Height Control Sensor Data Out of Range When Initializing  


DESCRIPTION

The headlight leveling ECU assembly stores this DTC if the sensor value received from the rear height control sensor sub-assembly LH is out of range when performing initialization of the headlight leveling ECU assembly; for example, the vehicle is not level or being jacked up.

DTC No. DTC Detecting Condition Trouble Area
B2452 Rear height control sensor sub-assembly LH is out of range when initializing
·

Vehicle condition when initializing

·

Headlight leveling ECU assembly



CAUTION / NOTICE / HINT

NOTICE:

If the headlight leveling ECU assembly has been replaced, initialization of the headlight leveling ECU assembly is necessary (See page Vehicle Interior>LIGHTING>LIGHTING SYSTEM(for LED Headlight)>INITIALIZATION).


PROCEDURE

1.PERFORM INITIALIZATION
a.

Perform initialization of the headlight leveling ECU assembly (See page Vehicle Interior>LIGHTING>LIGHTING SYSTEM(for LED Headlight)>INITIALIZATION).

HINT:
·

Before initializing the headlight leveling ECU assembly, make sure that the vehicle condition is proper for initialization.

·

Be sure to perform initialization as instructed.





NEXT

2.RECHECK FOR DTC
2.RECHECK FOR DTC
a.

Using the GTS, recheck for DTCs (See page Vehicle Interior>LIGHTING>LIGHTING SYSTEM(for LED Headlight)>DTC CHECK / CLEAR).

OK:

DTC B2452 is not output


HINT:

If the headlight leveling ECU assembly stores DTC B2452 even though the ECU has been initialized as instructed, the headlight leveling ECU assembly may be malfunctioning.




OK

END

NG

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY