85110R
1.INSTALL REAR WIPER MOTOR ASSEMBLY
Install the wiper motor with the 3 bolts.
Connect the connector.
85143R
2.INSTALL REAR WIPER MOTOR GROMMET
Apply grease to the lip circumference of the front wiper grommet.
Apply grease to the inner circumference of the lip without blocking the hole.
Install the rear wiper grommet.
Install the grommet with the mark facing upward as shown in the illustration.
85190R
3.INSTALL REAR WIPER ARM AND BLADE ASSEMBLY
Stop the wiper motor at the automatic stop position.
Clean the wiper arm serration with a round file or equivalent.
Clean the wiper pivot serration with a wire brush.
Install the arm and blade with the nut. Make sure that the arm and blade comes to the position shown in the illustration.
Hold down the arm hinge by hand while tightening the nut.
Install the arm and blade so that the rear wiper blade is aligned with the defogger line.
Install the cap as shown in the illustration.
67750
4.INSTALL BACK DOOR TRIM BOARD ASSEMBLY
62581H
5.INSTALL REAR WINDOW SIDE GARNISH RH
62582H
6.INSTALL REAR WINDOW SIDE GARNISH LH
67848
7.INSTALL BACK DOOR SERVICE HOLE COVER LH (for Power Back Door)
67939D
8.INSTALL BACK DOOR CENTER GARNISH
9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10.PERFORM INITIALIZATION
Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.