Home › Vehicle Interior › WIPER / WASHER › REAR WIPER MOTOR › from 2016.05
RM24M0E _58 Vehicle Interior _059565 WIPER / WASHER _0291970 REAR WIPER MOTOR A

WIPER / WASHER  REAR WIPER MOTOR  INSTALLATION  


PROCEDURE

Hide 85110R 1.INSTALL REAR WIPER MOTOR ASSEMBLY

E130187

a.

Install the wiper motor with the 3 bolts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


b.

Connect the connector.


Hide 85143R 2.INSTALL REAR WIPER MOTOR GROMMET

E125939

a.

Apply grease to the lip circumference of the front wiper grommet.

HINT:

Apply grease to the inner circumference of the lip without blocking the hole.



b.
E130188

Install the rear wiper grommet.

NOTICE:

Install the grommet with the mark facing upward as shown in the illustration.



Hide 85190R 3.INSTALL REAR WIPER ARM AND BLADE ASSEMBLY

E129769E01
0.315,2.6 1.119,2.792 0.804,0.192 10 Wire Brush 2.5,3.324 3.230,3.654 0.730,0.330 10 Wiper Pivot Serration 2.558,1.519 3.263,1.887 0.705,0.367 10 Wiper Arm Serration 1.75,1.354 2.376,1.626 2.376,1.626 2.519,1.626 false 1.509,3.149 1.342,2.698 1.342,2.698 1.196,2.698 false 2.128,3.481 2.339,3.411 2.339,3.411 2.459,3.411 false

a.

Stop the wiper motor at the automatic stop position.


b.

Clean the wiper arm serration with a round file or equivalent.


c.

Clean the wiper pivot serration with a wire brush.


d.
E130189

Install the arm and blade with the nut. Make sure that the arm and blade comes to the position shown in the illustration.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)

HINT:
·

Hold down the arm hinge by hand while tightening the nut.

·

Install the arm and blade so that the rear wiper blade is aligned with the defogger line.




e.
E130190

Install the cap as shown in the illustration.


Hide 67750 4.INSTALL BACK DOOR TRIM BOARD ASSEMBLY

Hide 62581H 5.INSTALL REAR WINDOW SIDE GARNISH RH

Hide 62582H 6.INSTALL REAR WINDOW SIDE GARNISH LH

Hide 67848 7.INSTALL BACK DOOR SERVICE HOLE COVER LH (for Power Back Door)

Hide 67939D 8.INSTALL BACK DOOR CENTER GARNISH

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 10.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.