This circuit sends a signal from the steering pad switch to the radio receiver.
The vehicle is equipped with an SRS such as the airbags. Before servicing (including removal or installation of parts), be sure to read the precautionary notice for the airbag system (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
Inspect the steering pad switch (see page Audio / Visual / Telematics>AUDIO / VIDEO>STEERING PAD SWITCH>INSPECTION).
Steering pad switch is normal.
OK
NG
Disconnect the G3 receiver connector.
Disconnect the G10 cable connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
|---|---|
| G3-7 (SW1) - G10-6 (AU1) | Below 1 Ω |
| G3-8 (SW2) - G10-5 (AU2) | Below 1 Ω |
| G3-6 (SWG) - G10-4 (EAU) | Below 1 Ω |
| G3-7 (SW1) - Body ground | 10 kΩ or higher |
| G3-8 (SW2) - Body ground | 10 kΩ or higher |
| G3-6 (SWG) - Body ground | 10 kΩ or higher |
OK
NG
Disconnect the G10 and j1 cable connectors.
Measure the resistance of the cable.
| Tester Connection | Specified Condition |
|---|---|
| G10-4 (EAU) - j1-8 (EAU) | Below 1 Ω |
| G10-6 (AU1) - j1-10 (AU1) | Below 1 Ω |
| G10-5 (AU2) - j1-9 (AU2) | Below 1 Ω |
OK
NG