84250A
1.INSTALL STEERING PAD SWITCH ASSEMBLY
Attach the claw to install the steering pad switch RH.
Install the screw.
Attach the claw to install the steering pad switch LH.
Install the screw.
Connect the connector to the spiral cable.
45117
2.INSTALL BEZEL LOWER LH
Install the bezel lower to the steering pad switch.
45116
3.INSTALL BEZEL LOWER RH
Install the bezel lower to the steering pad switch.
45130
4.INSTALL STEERING PAD ASSEMBLY
45187
5.INSTALL NO. 3 STEERING WHEEL COVER LOWER
45186
6.INSTALL NO. 2 STEERING WHEEL COVER LOWER
7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8.PERFORM INITIALIZATION
Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
45130
9.INSPECT STEERING PAD ASSEMBLY
10.CHECK SRS WARNING LIGHT