Home › Vehicle Interior › ENGINE HOOD / DOOR › HOOD LOCK CONTROL CABLE ASSEMBLY(for RHD) › from 2016.05
RM24M0E _58 Vehicle Interior _059569 ENGINE HOOD / DOOR _0292027 HOOD LOCK CONTROL CABLE ASSEMBLY(for RHD) A

ENGINE HOOD / DOOR  HOOD LOCK CONTROL CABLE ASSEMBLY(for RHD)  INSTALLATION  


PROCEDURE

Hide 53630 1.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY

a.

Install the cable to the clamps, wire harness protector and wire harness grommet as shown in the illustration.

B136919E02
1.229,1.792 0.771,0.5 0.771,0.5 0.927,0.5 false 3.76,1.854 3.938,0.74 3.938,0.74 4.094,0.74 false 5.854,1.479 6.042,2.073 false 1.604,7.76 1.813,8.458 1.813,8.458 1.958,8.458 false 4.438,4.542 4.615,7.115 false 0.958,0.448 1.448,0.625 0.49,0.177 10 false Cable 4.125,0.667 4.615,0.844 0.49,0.177 10 false Cable 5.906,2.083 6.396,2.26 0.49,0.177 10 false Cable 1.99,8.385 2.479,8.563 0.49,0.177 10 false Cable 3.875,7.156 5.531,7.333 1.656,0.177 10 false Hood Lock Control Cable


Hide 53601 2.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

a.
B136918

Connect the cable to the lever.


b.

Attach the 3 claws to install the lever.


Hide 53510 3.INSTALL HOOD LOCK ASSEMBLY

a.
B136911

Connect the cable to the lock.


b.

Install the lock with the 3 bolts.

Torque:
7.5 N*m (77 kgf*cm, 66 in.*lbf)


c.

Adjust the lock.


d.

w/ Hood Courtesy Switch:

Connect the connector.


Hide 53289A 4.INSTALL RADIATOR SUPPORT OPENING COVER

Hide 28800 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 6.PERFORM INITIALIZATION

a.

Perform initialization (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



Hide 7.CHECK SRS WARNING LIGHT