After moving the shift lever to M, it is possible to switch the shift range between "1" (S1 range) and "7" (S7 range) using the transmission control switch.
Moving the shift lever to "+" once raises the shift range by one, and moving the shift lever to "-" lowers the shift range by one.
Disconnect the transmission control switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 6 (IG) - 13 (S) | Shift lever in M, "+" or "-" | Below 1 Ω |
| 5 (SFTU) - 11 (E) | Shift lever held in "+" (Up-shift) | Below 1 Ω |
| 4 (SFTD) - 11 (E) | Shift lever held in "-" (Down-shift) | Below 1 Ω |
| 6 (IG) - 13 (S) | Shift lever not in M, "+" or "-" | 10 kΩ or higher |
| 5 (SFTU) - 11 (E) | Shift lever in M | 10 kΩ or higher |
| 4 (SFTD) - 11 (E) | Shift lever in M | 10 kΩ or higher |
| *1 | Component without harness connected
(Transmission Control Switch) |
OK
NG
Disconnect the transmission control switch connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G9-6 (IG) - Body ground | Engine switch on (IG) | 11 to 14 V |
| G9-6 (IG) - Body ground | Engine switch off | Below 1 V |
Turn the engine switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G9-11 (E) - Body ground | Always | Below 1 Ω |
| *1 | Front view of wire harness connector
(to Transmission Control Switch) |
OK
NG
Disconnect the ECM connectors.
Turn the engine switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| D2-74 (S) - Body ground | ·
Engine switch on (IG) ·
Shift lever in M, "+" or "-" |
11 to 14 V |
| D2-74 (S) - Body ground | ·
Engine switch on (IG) ·
Shift lever not in M, "+" or "-" |
Below 1 V |
Turn the engine switch off.
Disconnect the spiral cable sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A7-16 (SFTU) - Body ground | Shift lever held in "+" (Up-shift) | Below 1 Ω |
| A7-51 (SFTD) - Body ground | Shift lever held in "-" (Down-shift) | Below 1 Ω |
| A7-16 (SFTU) - Body ground | Shift lever in M | 10 kΩ or higher |
| A7-51 (SFTD) - Body ground | Shift lever in M | 10 kΩ or higher |
OK
NG
NEXT
NEXT