The ECM receives a signal from the secondary pulley speed sensor (transmission revolution sensor (NOUT)) installed in the continuously variable transaxle and determines the output shaft speed in order to control the gear ratio.
The transmission revolution sensor (NOUT) detects the continuously variable transaxle output shaft speed and sends it to the ECM.
| DTC No. | DTC Detection Condition
1.
Diagnosis Condition 2.
Malfunction Status 3.
Malfunction Time 4.
Other |
Trouble Area |
|---|---|---|
| P0722 | 1.
The vehicle is driven with the shift lever in D, the output shaft speed is 300 rpm or more, and no error is detected in the park/neutral position switch. 2.
The speed indicated by the transmission revolution sensor (NOUT) is less than 300 rpm. 3.
2 seconds 4.
1 trip detection logic |
·
Open or short in transmission revolution sensor (NOUT) circuit ·
Transmission revolution sensor (NOUT) ·
ECM |
The ECM receives a signal from the secondary pulley speed sensor (transmission revolution sensor (NOUT)) installed in the continuously variable transaxle and determines the output shaft speed in order to control the gear ratio.
If the ECM detects no signal from the secondary pulley speed sensor even while the vehicle is moving, it will conclude that there is a malfunction in the secondary pulley speed sensor. The ECM will illuminate the MIL and store the DTCs.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
In accordance with the display on the tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| SPD (NOUT) | Secondary pulley speed (NOUT)/
min.: 0 rpm max.: 12750 rpm |
·
Vehicle stopped: 0 rpm ·
Vehicle cruising at approx. 60 km/h (37 mph): 2650 rpm |
Data is displayed in increments of 50 rpm. |
| Result | Proceed to |
|---|---|
| Data displayed is not as specified under Normal Condition | A |
| Data displayed is as specified under Normal Condition | B |
A
B
Disconnect the transmission revolution sensor (NOUT) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (NOT-) - 2 (NOT+) | 20°C (68°F) | 560 to 680 Ω |
| *1 | Component without harness connected
(Transmission Revolution Sensor (NOUT)) |
OK
NG
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| D2-125 (NOT+) - D2-124 (NOT-) | 20°C (68°F) | 560 to 680 Ω |
| D2-125 (NOT+) - Body ground | Always | 10 kΩ or higher |
| D2-124 (NOT-) - Body ground | Always | 10 kΩ or higher |
OK
NG
NEXT
NEXT
NEXT
NEXT