Home › Drivetrain › K112 (CVT) › SPEED SENSOR
RM24M0E _52 Drivetrain _059572 K112 CVT _0292057 SPEED SENSOR A

K112 CVT  SPEED SENSOR  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 53292A 2.REMOVE UPPER RADIATOR SUPPORT SEAL

Hide 55712 4.REMOVE FRONT COWL TOP OUTSIDE PANEL WITH WINDSHIELD WIPER MOTOR AND LINK

Hide 89413B 8.REMOVE TRANSMISSION REVOLUTION SENSOR (NT)

C368312

a.

Disconnect the transmission revolution sensor (NT) connector.


b.

Remove the bolt and transmission revolution sensor (NT) from the continuously variable transaxle.


c.

Remove the O-ring from the transmission revolution sensor (NT).


Hide 89413B 9.REMOVE TRANSMISSION REVOLUTION SENSOR (NIN)

C368313

a.

Disconnect the transmission revolution sensor (NIN) connector.


b.

Remove the bolt and transmission revolution sensor (NIN) from the continuously variable transaxle.


c.

Remove the O-ring from the transmission revolution sensor (NIN).


Hide 89413B 10.REMOVE TRANSMISSION REVOLUTION SENSOR (NOUT)

a.
C366271

Remove the bolt and disconnect the ground cable from the continuously variable transaxle.


b.

Disconnect the clamp from the wire harness clamp bracket.


c.
C368314

Disconnect the transmission revolution sensor (NOUT) connector.


d.

Remove the bolt and transmission revolution sensor (NOUT) from the continuously variable transaxle.


e.

Remove the O-ring from the transmission revolution sensor (NOUT).