Home › Drivetrain › K112 (CVT) › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM › 2014.09–2016.05
RM24M0E _52 Drivetrain _059572 K112 CVT _0292047 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM C

K112 CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  U0129  Lost Communication with Brake System Control Module  


DESCRIPTION

The ECM receives signals sent from the skid control ECU via the CAN communication system. When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding ECU or sensor.

DTC No. DTC Detection Condition
1.

Diagnosis Condition

2.

Malfunction Status

3.

Malfunction Time

4.

Other


Trouble Area
U0129
1.

The engine switch is on (IG).

2.

There is no communication between the ECM and skid control ECU.

3.

2.4 seconds

4.

1 trip detection logic


·

CAN communication system

·

Brake actuator assembly (Skid control ECU)

·

ECM



PROCEDURE

1.CLEAR DTC AND PERFORM ROAD TEST
a.

Clear the DTCs (See page Drivetrain>K112 (CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DTC CHECK / CLEAR).

HINT:

Write down the currently output DTCs before clearing them.



b.

Start the engine and drive the vehicle at a low speed.



NEXT

2.CHECK DTC OUTPUT (DTC U0129)
2.CHECK DTC OUTPUT (DTC U0129)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / DTC.


e.

Check for DTCs using the intelligent tester.

Result
Result Proceed to
U0129 is not output A
U0129 is output B



A

B

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)