The ECM receives signals sent from the skid control ECU via the CAN communication system. When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding ECU or sensor.
| DTC No. | DTC Detection Condition
1.
Diagnosis Condition 2.
Malfunction Status 3.
Malfunction Time 4.
Other |
Trouble Area |
|---|---|---|
| U0129 | 1.
The engine switch is on (IG). 2.
There is no communication between the ECM and skid control ECU. 3.
2.4 seconds 4.
1 trip detection logic |
·
CAN communication system ·
Brake actuator assembly (Skid control ECU) ·
ECM |
Clear the DTCs (See page Drivetrain>K112 (CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DTC CHECK / CLEAR).
Write down the currently output DTCs before clearing them.
Start the engine and drive the vehicle at a low speed.
NEXT
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Check for DTCs using the intelligent tester.
| Result | Proceed to |
|---|---|
| U0129 is not output | A |
| U0129 is output | B |
A
B