Home › Drivetrain › K112 (CVT) › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM › 2013.04–2014.09
RM24M0E _52 Drivetrain _059572 K112 CVT _0292047 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM C

K112 CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  P0746  Pressure Control Solenoid "A" Performance (Shift Solenoid Valve DS1)  P0776  Pressure Control Solenoid "B" Performance (Shift Solenoid Valve DS2)  


DESCRIPTION

The ECM uses shift solenoid valves DS1 and DS2 to control the in/out CVT fluid flow volumes at the primary pulley to perform gear ratio control.

DTC No. DTC Detection Condition
1.

Diagnosis Condition

2.

Malfunction Status

3.

Malfunction Time

4.

Other


Trouble Area
P0746
1.

The engine is warmed up, and with the shift lever in D, the vehicle is accelerating.

2.

The actual gear ratio is higher than the target.

3.

2 seconds

4.

2 trip detection logic


Continuously variable transaxle assembly
1.

The engine is warmed up, and with the shift lever in D, the vehicle is decelerating or stopped.

2.

The actual gear ratio is lower than the target.

3.

1 second

4.

2 trip detection logic


P0776
1.

The engine is warmed up, and with the shift lever in D, the vehicle is decelerating or stopped.

2.

The actual gear ratio is lower than the target.

3.

1 second

4.

2 trip detection logic


1.

The engine is warmed up, and with the shift lever in D, the vehicle is accelerating.

2.

The actual gear ratio is higher than the target.

3.

2 seconds

4.

2 trip detection logic



MONITOR DESCRIPTION

The ECM compares the actual gear ratio with the target gear ratio. When the actual gear ratio and target gear ratio are different, the ECM detects the problem, illuminates the MIL and stores the DTC.

PROCEDURE

1.CHECK DTC OUTPUT (IN ADDITION TO DTC P0746 AND P0776)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / DTC.


e.

Read the DTCs using the tester.

Result
Result Proceed to
Only P0746 and P0776 are output A
P0746 or P0776 and other DTCs are output B

HINT:

If any other DTCs besides P0746 and P0776 are output, perform troubleshooting for those DTCs first.




A

2.REPLACE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY

B

2.REPLACE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY

NEXT

3.PERFORM INITIALIZATION