When the ECM receives an error signal from the brake actuator assembly (skid control ECU), DTC P1750 is stored.
| DTC No. | DTC Detection Condition
1.
Diagnosis Condition 2.
Malfunction Status 3.
Malfunction Time 4.
Other |
Trouble Area |
|---|---|---|
| P1750 | 1.
- 2.
The ECM receives an error signal from the brake actuator assembly (skid control ECU). 3.
3 seconds 4.
1 trip detection logic |
·
Anti-lock brake system ·
Vehicle stability control system |
Check for DTCs of the brake control system.
Anti-lock brake system (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR).
Vehicle stability control system (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output
(Vehicle stability control system) |
B |
| DTCs are output
(Anti-lock brake system) |
C |
A
B
C
(See pageBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DIAGNOSTIC TROUBLE CODE CHART)