Home › Drivetrain › K112 (CVT) › PARK / NEUTRAL POSITION SWITCH
RM24M0E _52 Drivetrain _059572 K112 CVT _0292050 PARK / NEUTRAL POSITION SWITCH A

K112 CVT  PARK / NEUTRAL POSITION SWITCH  REMOVAL  


PROCEDURE

Hide 53292A 1.REMOVE UPPER RADIATOR SUPPORT SEAL

Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 74431 4.REMOVE BATTERY TRAY

Hide 33820B 7.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Move the shift lever to N.


b.
C189455

Remove the nut and clip, and disconnect the control cable assembly from the control shaft lever.


Hide 84540 8.REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Disconnect the park/neutral position switch connector.


b.
C128919

Remove the nut, spring washer and control shaft lever.


c.
C211791E01
2.647,1.293 2.814,1.453 0.167,0.160 10 *1 2.733,1.293 2.733,1.121 false

Using a screwdriver, bend the tabs of the lock plate.

Text in Illustration
*1 Lock Plate


d.

Remove the lock nut and lock plate.


e.
C069812

Remove the 2 bolts and pull out the park/neutral position switch assembly to remove it.