1.REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
12311A
2.REMOVE FRONT ENGINE MOUNTING BRACKET
Remove the 3 bolts and front engine mounting bracket from the continuously variable transaxle assembly.
12321A
3.REMOVE REAR ENGINE MOUNTING BRACKET
Remove the 3 bolts and rear engine mounting bracket from the continuously variable transaxle assembly.
28100
4.REMOVE STARTER ASSEMBLY
Disconnect the connector from the starter assembly.
Open the terminal cap, remove the nut and disconnect the starter wire.
Remove the 2 bolts and starter assembly from the continuously variable transaxle assembly.
82121
5.DISCONNECT ENGINE WIRE
Disconnect the transmission wire connector, park/neutral position switch connector, and 3 revolution sensor connectors, and detach the 4 wire harness clamps from the continuously variable transaxle assembly.
Disconnect the oil pressure sensor connector and detach the 2 wire harness clamps from the continuously variable transaxle assembly.
6.REMOVE WIRE HARNESS CLAMP BRACKET
Remove the bolt and disconnect the ground cable from the wire harness clamp bracket.
| *1 | Ground Cable |
Remove the 2 bolts, shift cable bracket and 2 wire harness clamp brackets from the continuously variable transaxle assembly.
33493B
7.REMOVE OIL COOLER
Release the 4 clamps and remove the 2 oil cooler hoses from the oil cooler and continuously variable transaxle assembly.
Release the 2 clamps and disconnect the 2 water by-pass hoses from the oil cooler.
Remove the 3 bolts and oil cooler from the continuously variable transaxle assembly.
11361J
8.REMOVE FLYWHEEL HOUSING UNDER COVER
Remove the flywheel housing under cover from the engine assembly.
30400
9.REMOVE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY
Turn the crankshaft to gain access and remove the 6 drive plate and torque converter assembly setting bolts while holding the crankshaft pulley bolt with a wrench.
Remove the 9 bolts and continuously variable transaxle assembly from the engine assembly.
| *1 | Knock Pin |
To prevent damage to the knock pins, do not pry between the continuously variable transaxle assembly and engine assembly.
33823
10.REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET
Remove the 2 bolts and No. 1 transmission control cable bracket from the continuously variable transaxle assembly.
12325A
11.REMOVE ENGINE MOUNTING BRACKET LH
Remove the 3 bolts and engine mounting bracket LH from the continuously variable transaxle assembly.
32000A
12.REMOVE TORQUE CONVERTER ASSEMBLY
Remove the torque converter assembly from the continuously variable transaxle assembly.
30400E
13.REMOVE CVT OIL PUMP TYPE T OIL SEAL
Do not remove the front oil pump assembly from the CVT main body, as there is the possibility of the entry of dust and foreign matter.
Clean the work area, the tools to be used, and other equipment, etc. thoroughly before the operation, as there is the possibility that a CVT malfunction, which could prevent the vehicle from moving, could occur if dust or fine foreign matter enters the CVT.
Do not use cotton work gloves, cloths, or paper towels, etc. that may produce lint, dust or foreign matter.
Perform the operation as quickly as possible, as dust and foreign matter could enter the CVT while the torque converter is not attached to it.
Do not use an air gun until the torque converter has been installed, as it could cause dust and foreign matter to be stirred up.
Clean the tips of both claws of SST and the center bolt.
Using SST, remove the CVT oil pump type T oil seal.
Pay attention to the angle of the claws when opening them, and ensure that they do not come into contact with the oil pump housing, as there is the possibility that metal particles could be produced if they do.
32000A
14.INSPECT TORQUE CONVERTER ASSEMBLY
32101
15.INSPECT DRIVE PLATE & RING GEAR SUB-ASSEMBLY