Home › Drivetrain › K112 (CVT) › OIL PRESSURE SENSOR › 2013.04–2014.09
RM24M0E _52 Drivetrain _059572 K112 CVT _0292056 OIL PRESSURE SENSOR A

K112 CVT  OIL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89637K 1.INSTALL OIL PRESSURE SENSOR

a.

Coat the O-ring of the pressure sensor with Toyota Genuine CVT Fluid FE.


b.

Using SST, install the oil pressure sensor to the continuously variable transaxle.

SST
09326-22011  

Torque:
without SST : 21 N*m (210 kgf*cm, 15 ft.*lbf)
with SST : 16 N*m (159 kgf*cm, 12 ft.*lbf)

NOTICE:
·

The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 155 mm (6.10 in.).

·

The "with SST" torque value is effective when SST is parallel to the torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




c.

Connect the oil pressure sensor connector.


Hide 53702 2.INSTALL FRONT FENDER APRON LH

Hide 4.RESET MEMORY

HINT:

Perform Reset Memory (CVT initialization) when replacing the oil pressure sensor (See page Drivetrain>K112 (CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION).