Home › Engine / Hybrid System › 2GR-FE STARTING › SMART ENTRY AND START SYSTEM › 2014.09–2016.05
RM24M0E _51 Engine / Hybrid System _059574 2GR-FE STARTING _0292072 SMART ENTRY AND START SYSTEM T

2GR-FE STARTING  SMART ENTRY AND START SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of a problem. The likely causes of the problem are indicated in descending order. Check each suspected area in order. Repair or Replace faulty parts or perform adjustments as necessary.

·

Inspect the fuses and relays related to the system before inspecting the suspected areas below.



Smart Entry and Start System
Symptom Suspected Area See page
Power does not turn on (neither ACC nor IG is possible). Fuse (Click here)
Engine Switch -
Wire Harness or Connector -
Smart Entry and Start System (Entry Function) -
Main Body ECU (Instrument Panel Junction Block LH) -
Certification ECU -
ID Code Box -
Power is not turned on (only ACC is not turned on). Fuse (Click here)
Instrument Panel Junction Block RH -
Wire Harness or Connector -
Main Body ECU (Instrument Panel Junction Block LH) -
Power is not turned on (only IG is not turned on). Fuse (Click here)
Instrument Panel Junction Block RH -
IG2 Relay -
Wire Harness or Connector -
Main Body ECU (Instrument Panel Junction Block LH) -
Engine does not start. Smart Entry and Start System (Entry) (Click here)
Engine Switch -
Shift Lock Control ECU -
STOP Fuse -
Stop Light Switch -
Electrical Steering Lock Function -
ST CUT Relay -
Park/Neutral Position Switch -
ST Relay -
ECM -
Engine Immobiliser System -
Main Body ECU (Instrument Panel Junction Block LH) -
Wire Harness or Connector -
Engine switch indicator light does not come on. Engine Switch Indicator Light Circuit (Click here)