This DTC is output when serial communication signals and CAN communication signals in the circuit between the main body ECU and ECM are inconsistent.
When the main body ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU is replaced, perform the registration procedures for the engine immobiliser system.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2286 | Serial communication signals and CAN communication signals in the circuit between the main body ECU and ECM are inconsistent. | ·
CAN communication system ·
ECM ·
Instrument panel junction block LH (Main body ECU) ·
Wire harness or connector |
Run the engine and check if the function of the tachometer in the combination meter is normal.
Actual engine revolution speed and the revolution indicated on the tachometer are the same.
OK
NG
Delete the DTCs (See page Engine / Hybrid System>2GR-FE STARTING>SMART ENTRY AND START SYSTEM>DTC CHECK / CLEAR).
Check for CAN communication system (See page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).
If the DTCs for the CAN communication system malfunction are output, inspect those DTCs first (See page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
No DTC is output.
OK
NG
Disconnect the A7 ECM connector.
Disconnect the G59 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G59-8 (TACH) - A7-15 (TACH) | Always | Below 1 Ω |
| G59-8 (TACH) or A7-15 (TACH) - Body ground | Always | 10 kΩ or higher |
OK
NG
Reconnect the connectors.
Connect the intelligent tester to the DLC3.
Check the DATA LIST for proper functioning of the engine.
When using the intelligent tester with the engine switch off, turn on and off any of the door courtesy light switches repeatedly at 1.5 second intervals or less until communication between the tester and vehicle starts.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| E/G Cond | Engine condition/STOP or RUN | STOP: Engine is stopped
RUN: Engine is running |
- |
STOP (engine is stopped) and RUN (engine is running) appear on the screen.
OK
NG