Home › Drivetrain › U241E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSAXLE SYSTEM › 2014.09–2016.05
RM24M0E _52 Drivetrain _059578 U241E AUTOMATIC TRANSMISSION / TRANSAXLE _0292096 AUTOMATIC TRANSAXLE SYSTEM T

U241E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

The Matrix Chart is divided into 2 chapters. When troubleshooting, check Chapter 1 first. If instructions are given in Chapter 1 to proceed to 2, proceed as instructed.

·

If the instruction "Proceed to next circuit inspection shown in problem symptoms table" is given in the flowchart for each circuit, proceed to the next suspected area in the table.

·

If the problem still occurs even though there are no malfunctions in any of the circuits, check the ECM and replace it if necessary.



CHAPTER 1: ELECTRICAL CIRCUIT MATRIX CHART
Symptom Suspected Area See page
No up-shift (1st -> 2nd) ECM (Click here)
No up-shift (2nd -> 3rd) ECM (Click here)
No up-shift (3rd -> O/D) 1. Park/Neutral position switch circuit* (Click here)
2. ECM (Click here)
No down-shift (O/D -> 3rd) ECM (Click here)
No down-shift (3rd -> 2nd) ECM (Click here)
No down-shift (2nd -> 1st) ECM (Click here)
No lock-up or no lock-up off ECM (Click here)
Shift point too high or too low ECM (Click here)
Up-shift to O/D from 3rd while shift lever is on 3 1. Park/Neutral position switch circuit* (Click here)
2. ECM (Click here)
Up-shift to O/D from 3rd while engine is cold 1. Engine coolant temp. sensor circuit* (Click here)
2. ECM (Click here)
Harsh engagement (N -> D) ECM (Click here)
Harsh engagement (lock-up) ECM (Click here)
Harsh engagement (any driving position) ECM (Click here)
Poor acceleration ECM (Click here)
Engine stalls when starting off or stopping ECM (Click here)
Malfunction in shifting 1. Park/Neutral position switch circuit* (Click here)
2. ECM (Click here)

HINT:

*: When the circuit is defective, a DTC may be output.


CHAPTER 2: ON-VEHICLE REPAIR AND OFF-VEHICLE REPAIR
Symptom Suspected Area See page
Vehicle does not move in all positions other than P and N 1. Manual valve (Click here)
2. Primary regulator valve (Click here)
3. Front and rear planetary gear (Click here)
4. U/D planetary gear (Click here)
5. F2 U/D one-way clutch (Click here)
6. C1 forward clutch (Click here)
7. B3 U/D brake (Click here)
Vehicle does not move with shift lever on R 1. Front and rear planetary gear (Click here)
2. U/D planetary gear (Click here)
3. C2 direct clutch (Click here)
4. C3 U/D brake (Click here)
5. B2 1st and reverse brake (Click here)
No up-shift (1st -> 2nd) 1. Valve body assembly (Click here)
2. F1 No. 1 one-way clutch (Click here)
3. B1 2nd brake (Click here)
No up-shift (2nd -> 3rd) 1. Valve body assembly (Click here)
2. C2 direct clutch (Click here)
No up-shift (3rd -> O/D) 1. 3-4 shift valve (Click here)
2. C3 U/D clutch (Click here)
No down-shift (O/D -> 3rd) 3-4 shift valve (Click here)
No down-shift (3rd -> 2nd) Valve body assembly (Click here)
No down-shift (2nd -> 1st) Valve body assembly (Click here)
No lock-up or no lock-up off 1. Lock-up relay valve (Click here)
2. Torque converter assembly (Click here)
Harsh engagement (N -> D) 1. C1 accumulator (Click here)
2. Valve body assembly (Click here)
3. C1 forward clutch (Click here)
4. F2 U/D one-way clutch (Click here)
5. F1 No. 1 one-way clutch (Click here)
Harsh engagement (N -> R) 1. Valve body assembly (Click here)
2. C2 direct clutch (Click here)
3. B2 1st and reverse brake (Click here)
Harsh engagement (Lock-up) 1. Lock-up relay valve (Click here)
2. Torque converter assembly (Click here)
Harsh engagement (2nd -> 3rd) Valve body assembly (Click here)
Harsh engagement (3rd -> O/D) Valve body assembly (Click here)
Harsh engagement (O/D -> 3rd) Valve body assembly (Click here)
Slip or shudder (forward position, after warm-up) 1. Oil strainer (Click here)
2. Torque converter assembly (Click here)
3. C1 forward clutch (Click here)
4. C2 direct clutch (Click here)
5. C3 U/D brake (Click here)
6. F1 No. 1 one-way clutch (Click here)
7. F2 U/D one-way clutch (Click here)
Slip or shudder (shift lever on R) 1. Oil strainer (Click here)
2. C2 direct clutch (Click here)
3. B2 1st and reverse brake (Click here)
Slip or shudder (1st) F1 No. 1 one-way clutch (Click here)
Slip or shudder (2nd) 1. F2 U/D one-way clutch (Click here)
2. B1 2nd brake (Click here)
Slip or shudder (3rd) C2 direct clutch (Click here)
Slip or shudder (O/D) C3 U/D clutch (Click here)
No engine braking (1st to 3rd/shift lever on D) B3 U/D brake (Click here)
No engine braking (1st/shift lever on L) B2 1st and reverse brake (Click here)
No engine braking (2nd/shift lever on 2) B1 2nd brake (Click here)
Poor acceleration (all positions) 1. Torque converter assembly (Click here)
2. U/D planetary gear (Click here)
Poor acceleration (O/D) 1. C3 U/D clutch (Click here)
2. U/D planetary gear (Click here)
Large shift shock or engine stalls when starting off or stopping Torque converter assembly (Click here)
No kick-down Valve body assembly (Click here)