Home › Drivetrain › U241E (AUTOMATIC TRANSMISSION / TRANSAXLE) › PARK / NEUTRAL POSITION SWITCH › 2013.04–2014.09
RM24M0E _52 Drivetrain _059578 U241E AUTOMATIC TRANSMISSION / TRANSAXLE _0292098 PARK / NEUTRAL POSITION SWITCH A

U241E AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 84540 1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

C132993

a.

Install the switch to the manual valve shaft.


b.

Temporarily install the 2 bolts.


c.
C132994

Install a new lock washer and tighten the manual valve shaft nut.

Torque:
6.9 N*m (70 kgf*cm, 61 in.*lbf)


d.

Temporarily install the control shaft lever.


e.
C132995E02
0.646,1.594 0.802,1.792 0.156,0.198 10 false N

Turn the lever counterclockwise until it stops, and then turn it clockwise 2 notches.


f.

Remove the control shaft lever.


g.
C132996E05
2.031,0.927 1.458,0.125 1.458,0.125 1.25,0.125 true 2,1.094 2.865,1.448 true 0.083,0.042 1.271,0.375 1.188,0.333 10 true Neutral Basic Line 2.906,1.396 3.375,1.573 0.469,0.177 10 true Groove

Align the groove with neutral basic line.


h.

Hold the switch in this position and tighten the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


i.
C132992

Using a screwdriver, stake the nut with the lock washer.


j.
C132991

Install the control shaft lever with the washer and nut.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


k.

Connect the shift control cable to the control shaft lever with the nut.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)


l.

Connect the switch connector.


Hide 2.INSTALL BATTERY

a.

Install the battery bracket reinforcement with the 2 bolts.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


b.

Install the battery carrier with the 4 bolts.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


c.

Insert the No. 2 air cleaner inlet to the bracket with the bolt.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


d.

Attach the 2 wire harness clamps.


e.

Install the battery tray.


f.

Install the battery with the battery clamp.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)

for nut



Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 4.ADJUST SHIFT LEVER POSITION

Hide 84540 5.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

Hide 6.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.