Home › Drivetrain › U241E (AUTOMATIC TRANSMISSION / TRANSAXLE) › TRANSMISSION WIRE
RM24M0E _52 Drivetrain _059578 U241E AUTOMATIC TRANSMISSION / TRANSAXLE _0292099 TRANSMISSION WIRE A

U241E AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION WIRE  INSTALLATION  


PROCEDURE

Hide 82125J 1.INSTALL TRANSMISSION WIRE

a.
C367490

Coat a new O-ring with ATF and install it to the transmission wire.


b.
C132997

Install the transmission wire.


c.

Install the bolt.


d.

Connect the connector.


e.
D025591E13
2.594,0.438 2.531,0.438 false 2.531,0.438 2.531,1.302 false 2.635,0.344 3.313,0.5 0.677,0.156 10 false Lock Plate

Coat the O-ring of the ATF temperature sensor with ATF.


f.

Install the ATF temperature sensor with the lock plate and bolt.

Torque:
6.6 N*m (67 kgf*cm, 58 in.*lbf)


g.

Connect the 5 shift solenoid valve connectors.


Hide 35106D 2.INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

a.
C134981E06
2.365,1.021 2.688,1.323 false 2.688,1.323 1.75,1.021 false 2.677,1.323 2.01,1.781 false 2.74,1.24 3.271,1.417 0.531,0.177 10 false Magnet

Install the 3 magnets in the oil pan.


b.
C083111

Install a new gasket and the oil pan with the 18 bolts.

Torque:
7.8 N*m (80 kgf*cm, 69 in.*lbf)


Hide 51441 3.INSTALL NO. 1 ENGINE UNDER COVER

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 5.ADD AUTOMATIC TRANSAXLE FLUID

Fluid type:

Toyota Genuine ATF WS


Hide 6.INSPECT TRANSAXLE FLUID LEVEL

Hide 7.PERFORM RESET MEMORY

a.

Perform the RESET MEMORY procedures (A/T initialization) (see page Drivetrain>U241E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE SYSTEM>INITIALIZATION).


Hide 8.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.