Home › Drivetrain › U241E (AUTOMATIC TRANSMISSION / TRANSAXLE) › SHIFT LEVER › 2013.04–2016.05
RM24M0E _52 Drivetrain _059578 U241E AUTOMATIC TRANSMISSION / TRANSAXLE _0292103 SHIFT LEVER A

U241E AUTOMATIC TRANSMISSION / TRANSAXLE  SHIFT LEVER  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 33504F 2.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

Hide 55420A 3.REMOVE INSTRUMENT CLUSTER FINISH PANEL CENTER ASSEMBLY

Hide 55414A 4.REMOVE INSTRUMENT CLUSTER FINISH PANEL END

Hide 55650 5.REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55042B 6.REMOVE NO. 2 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY

Hide 55660 7.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55041B 8.REMOVE NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY

Hide 55474B 9.REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55447C 10.REMOVE NO. 1 SWITCH HOLE BASE

Hide 55550 11.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 55606 12.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 58534E 13.REMOVE FLOOR CARPET COVER CENTER RH

Hide 58533C 14.REMOVE FLOOR CARPET COVER CENTER LH

Hide 55432B 15.REMOVE INSTRUMENT PANEL FINISH PANEL LOWER

Hide 55434B 16.REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER

Hide 55900A 17.REMOVE HEATER CONTROL AND ACCESSORY ASSEMBLY

Hide 33820B 18.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

C133003

a.

Disconnect the control cable from the shift lever.


b.
C133004E04
1.865,0.958 2.406,1.042 true 1.771,0.615 2.427,0.625 true 2.448,0.969 3,1.302 0.552,0.333 10 true Stopper 2.479,0.542 2.74,0.875 0.26,0.333 10 true Nut

Using a screwdriver, pull out the stopper of the transmission control cable.

NOTICE:

Do not remove the stopper. If the stopper is removed, reinstall it to its original position.



c.

Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable from the shift lever retainer.

NOTICE:

Do not over-rotate the nut as it will come off the interior spring and the transmission control cable will not be reusable.



Hide 19.REMOVE SHIFT LEVER ASSEMBLY

C133013

a.

Remove the 4 bolts, screw and shift lever.


b.

Disconnect the 2 connectors.